记作业>英语词典>chamfer翻译和用法

chamfer

英 [ˈtʃæmfə(r)]

美 [ˈtʃæmfər]

n.  斜切面; 削角

复数:chamfers 现在分词:chamfering 过去分词:chamfered 过去式:chamfered 第三人称单数:chamfers 

COCA.44768

牛津词典

    noun

    • 斜切面;削角
      a cut made along an edge or on a corner so that it slopes rather than being at 90˚

      英英释义

      noun

      • two surfaces meeting at an angle different from 90 degrees
          Synonym:bevelcant

        verb

        • cut a furrow into a columns
            Synonym:furrowchase
          1. cut a bevel on
            1. bevel the surface
            Synonym:bevel

          双语例句

          • Single type angle drills: Use to machine chamfer for hole of glass, stones etc. Various type and specification.
            独立倒角钻头:用于玻璃孔、石材孔倒角使用。各种型号及规格。
          • The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
            加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。
          • This paper analyzes the lack of traditional settingout method and the advantage of digitalization settingout method when analyzing settingout of chamfer stake in cubic meter of earth and stone.
            分析了土石方工程中坡口桩放样时,传统放样方法的不足和数字化放样方法的优点。
          • Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
            如有必要,请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。
          • After too large tooth resultant force is eliminated, tooth chamfer bone is OK proper motion rehabilitate, of the tooth become loose degree also return to normal subsequently;
            当过大的牙合力消除后,牙槽骨可以自行修复,牙齿的松动度也随之恢复正常;
          • Select those front edges and chamfer them then click apply and chamfer it again but this time with a lower value.
            选择前面的边并倒角,然后单击应用并以较低的值再次倒角。
          • Or just the dimensions related to big chamfer?
            或者只是尺寸大倒角?
          • RECHAMFER: Defect on radii and chamfer; defective chamfer such as nicks that are considered to be repairable.
            重新倒角:可被重新修复的倒角缺陷,例如划痕。
          • Programming Method of Milling of Chamfer and Fillet Based on$ TC_DP
            基于$TCDP铣削斜面及倒圆角的程序编制方法
          • Also, the chamfer of the stay vanes entrance and the surface roughness of the flow channel were optimized by the numerical investigations.
            亦对固定导叶入口冲角、涡壳壁面粗糙度对流动的影响进行了定量分析。