rigidness

英

美

网络  刚度; 僵化; 烧火棍管的刚度

英英释义

noun

• the quality of being rigid and rigorously severe
  Synonym:inflexibilityrigidity
• the physical property of being stiff and resisting bending
  Synonym:rigidity

双语例句

• By comparing static and kinetic rigidity with some examples, measures of raising the kinetic rigidness of tools are suggested.
  通过动、静刚度的对比和一些实例，得出了提高机床动刚度的措施。
• ⑵ Typical working conditions analysis: In the bases of FEA model, this paper analyzed bus-body structure under three typical working conditions, and checked its strength and rigidness of top-body frame.
  ⑵在大客车车身结构有限元模型基础上，对车身及顶部骨架结构进行了弯曲、扭转及紧急制动三种典型工况下的结构分析，并校核了其刚度和强度。
• For this reason, the present paper, according to the strength rigidness requirements and stable limit of bearing capacity of compression bar, the notched height of reinforced concrete tower building can be calculated.
  为此，本文根据压杆的强度、刚度要求和稳定承载能力极限，应用钢结构设计原理，计算钢筋混凝土高耸建筑物的切口高度。
• The material that is applied in the automotive interior trim parts should be well balanced in rigidness and toughness, and should have a good dimensional stability and long-term reliability. Besides, the material should not release hazard substances.
  应用于汽车内饰件的材料应具备均衡的刚性和韧性、良好的尺寸稳定性、长期使用可靠性，并且不能释放出有毒有害物质。
• Taking the die structure of typical punching parts shaving die as an example, since restricted by the parts size itself, the intension and rigidness of concave die is seriously affected.
  以典型冲压件整修模的模具结构为例。因受零件自身尺寸的限制，极大影响了模具凹模的强度和刚度。
• For the sleeve bearing motor, the clearance between bearing and bush should be controlled and the rigidness of supporting should be strengthened.
  针对滑动轴承电动机，采取控制轴瓦间隙、加强支承刚度解决振动问题等；
• As far as English-Chinese translation is concerned, the translation of relative clause is not only important but also difficult, and it is mainly responsible for the rigidness of most translation.
  就英译汉而论，定语从句的翻译既是重点又是难点，大凡译文之生硬、拗口甚至晦涩多半与没能译好关系从句有关。
• T beam horizontal laying calculation method based upon rigidness correction
  基于刚度修正的T梁横向分布计算方法
• Directing against the operating condition and tubulature stress calculation, a technical scheme for remedy of the said vibration has been worked out, to install vibration damper for enhancing the rigidness of said pipeline.
  针对运行工况和管系应力计算，制定了加设减振装置，提高管系刚度的振动治理技术方案，治理后管系振动明显降低。
• A Study on Meshing Rigidness and Dynamic Property of Gear Transmission Used for the Warship
  舰船用齿轮传动啮合刚度及动态性能研究