记作业>英语词典>scuffing翻译和用法

scuffing

英 [ˈskʌfɪŋ]

美 [ˈskʌfɪŋ]

v.  磨损; 磨坏; 拖着脚走
scuff的现在分词

现在分词:scuffing 

柯林斯词典

  • V-ERG (使)磨损;(使)磨坏
    If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.
    1. Constant wheelchair use will scuff almost any floor surface...
      任何地板上经常有轮椅走动几乎都会有所磨损。
    2. Molded plastic is almost indestructible, but scuffs easily.
      注塑几乎弄不坏,但是容易磨损。
  • VERB 拖着脚走
    If youscuffyour feet, you pull them along the ground as you walk.
    1. Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
      波莉既困惑又尴尬,低下头拖着脚走开了。

双语例句

  • The scuffing resistances of three phosphate coatings of manganese are evaluated in a MQ-800 four ball tester equipped with a new wear sample holder.
    在MQ&800四球试验机上装配了一种新的磨损试验夹具,评价了三种磷酸锰盐涂层的抗擦伤性能;
  • The mould test demonstrates that the surface scuffing and metal transferring can be greatly deduced at dry friction condition.
    模具试验表明,复合镀层有效地降低了干摩擦状态下注塑模推管与摩擦件的表面划伤与金属转移。
  • The coatings has good antifogging property as well as good transparent and resistance to scuffing property.
    实验结果表明,该涂料具有优良的防雾性能,以及优良的透明性和抗擦伤性。
  • Effect of EP Additive Content on Scuffing Resistance to Heavy-duty Gears
    极压添加剂含量对重载齿轮抗胶合能力的影响
  • Study on calculating and test method for gear scuffing
    齿轮胶合的计算和试验研究
  • Effect of Lubricating Oil Temperature on Gear's Scuffing Resistance
    润滑油温度对齿轮胶合承载能力的影响
  • Tess twisted her feet to make a scuffing noise.
    苔丝缠绕着她的两只脚发出摩擦的声音。
  • It was found that when using non-EP lubricating oil the scuffing temperature is stable.
    试验结果表明,使用非极压润滑油时胶合温度是稳定的,而使用极压润滑油时,胶合温度受油温影响很大。
  • The experimental results showed there exists influence of the oil temperature on the scuffing resistant.
    试验结果表明:供油温度对摩擦副的抗咬死性能有较大的影响。
  • Numerical investigation on interaction of axial and lateral response for super-long pile The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
    轴-横向荷载作用下超长桩数值模拟为了避免划伤,轴承上的最大负荷应该总是小于其卸载负荷。